- per page
Bird Electronic Corp. - Element, 100E, 400-1000 MHz, 100W
BIRD 43 WATT POWER METER ELEMENT SLUG 10A 10W 25-60MHz
BIRD 43 WATT POWER METER ELEMENT SLUG 10A 10W 25-60MHz
Bird Electronic Corp. 110-1 Element,
110-1 110 - 160MHz, 1W
Bird Electronic Corp. 250A Element,
250A 25 - 60MHz, 250W
Bird Electronic Corp. 250H Element,
250H 2 - 30MHz, 250W
Bird Electronic Corp. 25C Element,
25C 100 - 250MHz, 25W
Bird 4274-025 Sampler Element 500w 25-1000 MHz
This item is a Bird 4274-025 plug-in sampler element for your service bench for the Bird 43 wattmeters.
This device is used to send an unrectified RF signal to another piece of test equipment like a spectrum analyzer, service monitor or oscilloscope.
The output signal is a fixed -50 dB approximate from the signal passing through the wattmeter.
The sampler is rated for operation from 20 to 1000 MHz.
The sampling signal is available at a BNC connector on the unit.
Bird 43 Leather Case
This is a must have to protect your Bird meter, Under the lid it stores 6 plus slugs
It is an original case and in very good and clean condition.
They are getting very hard to find now.
Bird 43 RF System complete, used 1 time only
Supplied to a local company who were advised this is what they needed to accuratly measure RF in their system, well it was used the day it was delivered and returned back in to the box.
Supplied as shown with attenuators, adapters, Slugs, patch lead, dummy load, factory case and owners manual.
The supplied slugs include
5E
100E
100A
MA-44001 1kw at 2.5GHz
50db wideband 500w attenuator
100C
The system is like new and supplied as shown
Bird 500A Element for Bird 43 Wattmeter 500W, 25-60 MHz
BIRD 43 WATT POWER METER ELEMENT SLUG 50B, 50-125 MHz, 50W
Bird Electronic Corp. 50C Element,
50C 100 - 250MHz, 50W
BIRD 43 WATT POWER METER 50D
50D, 200 - 500 MHz, 50W
Bird Electronic Corp. 50H Element,
50H 2 - 30MHz, 50W
Bird Electronic Corp. 5A Element,
5A 25 - 60MHz, 5W
Bird Electronic Corp. 5C Element,
5C 100 - 250MHz, 5W
Bird 8401 Termaline RF Load
Bird 8401 Termaline RF Coaxial Termination 600Watt, Oil-Cooled, N Female Connector
- Rugged portable Bench load for medium power base station RF testing up to 2.5 GHz.
- Oil-assisted convection cooling for safe, continuous operation up to 600W full rated power.
- Quick Change (QC) connectors to minimize the need for adaptors when making critical measurements.
- Low-profile housing with handle and rubber feet for trouble-free operation in the most demanding environments.
- Ambient Temperature: -40 C to +45 C
- Connector: QC type (Female N normally supplied)
- Finish: Gray powder coat
- Frequency Range and VSWR: DC-1 GHz at 1.1 max, 1-2.8 GHz at 1.2 max., 2.8-3 GHz at 1.3 max
- Load Coolant: 0.7 gal. (2.73 liters) refined mineral oil
- Nominal Size: 16 13/16" H x 8 1/2" W x 5 15/16" D, (427 mm x 216 mm x 151 mm)
- Operating Position: Horizontal only
- Power Rating: 600 W continuous
- Weight: 20 lbs. (9.1 kg)
The Model 8401 TERMALINE Load Resistor is a portable, self-contained general purpose 50 ohm coaxial transmission line termination requiring no outside power source or additional equipment. It provides accurate, dependable, and practically non-reflective termination for testing and adjusting transmitters under non-radiating conditions. The load consists essentially of a cylindrical film type resistor immersed in a dielectric coolant. The resistor, individually selected for its accuracy, is enclosed in a special tapered housing which provides a linear reduction in surge impedance directly proportional to the distance along the resistor. This produces the uniform, practically reflectionless line termination from dc to 2.5 GHz
- per page
